>

Hyundai Equus: Front Wiper Motor Repair procedures - Windshield Wiper/Washer - Body Electrical System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Front Wiper Motor Repair procedures

Removal
1.
Remove the windshield wiper arm (A) and blade after removing a nut.

Tightening torque :
27 ~ 31 N.m (2.8 ~ 3.2 kgf.m, 20 ~ 23 lb-ft)

2.
If necessary of removing the wiper blade, push both sides of lock buttons (A) and then remove the wiper blade.

3.
Remove the weather strip then remove the cowl top cover (A) after removing clips.

4.
Remove the windshield wiper motor and linkage assembly after removing 4 bolts. Disconnect the wiper motor connector (A) and windshield deicer connector (B) from the wiper motor & linkage assembly.

Tightening torque :
7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5.0 ~ 7.9 lb-ft)

Installation
1.
Install the wiper arm and blade to the specified position.

   
For your convenience, move the windshield wiper blades to the service position as follows;
1.
Turn the ignition OFF
2.
Move the wiper switch to the single wiping position and hold the switch until the wiper arm is in the fully up position.
3.
Raise the wiper arm.
4.
Replace the blade assembly.
5.
Return the wiper arm on the windshield.
6.
Turn the ignition to the ON position.
7.
Move the wiper switch to any position and then to the OFF position.
   
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
   
Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.
    Front Wiper Motor Components and Components Location
    Components 1. Nut cap2. Nut3. Wiper arm4. Wiper blade5. Cowl top cover braket6. Cowl top cover7. Washer bolt8. Wiper motor & linkage assembly ...

    Front Washer Motor Repair procedures
    Removal     1) When servicing the washer pump, be careful not to damage the washer pump seal. 2) Do not operate the washer pump before filling the washer reservoir. Failure ...

    See also:

    Tire specification and pressure label
    The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures re ...

    Rain Sensor Description and Operation
    Description Integrated Rain Sensor Integrated rain sensor (A) controls three systems: front wiper, auto-light, and central air conditioner. 1. Wiper Control System When "AUTO" switch signal i ...

    Repair procedures
    Fuel Pressure Test 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")     When removing the fuel pump re ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com