>
Inspection |
1. |
Check the power trunk module input/output value by using the
GDS. If the operation of power trunk module is abnormal, replace power
trunk drive unit. |
2. |
To check the DTC of the power trunk module, select "PTM" |
3. |
Select "Input/output monitoring". |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk") |
3. |
Disconnect the power striker connector (A). |
4. |
Remove the power striker (A) after removing the screws. |
Installation |
1. |
Install the power striker and connector. |
2. |
Install the trunk trim. |
3. |
Connect the negative (-) battery terminal and check the power trunk module correctly. |
Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams
Circuit Diagram
...
Solenoid Valve Schematic Diagrams
Circuit diagram
1.
Solenoid valve connector terminal
2.
Solenoid valve terminal function
TerninalFunction1Air spring valve FL2Ambiance valve3Air spring valve RR4Air spring valve RL5Solenoid ...
Seat Belt Buckle Switch (BS) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
3.
...