>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk") |
3. |
Remove the power latch (A) after removing the bolts (2EA) and connector (B). |
Installation |
1. |
Install the power latch and connector. |
2. |
Install the trunk trim. |
3. |
Connect the negative (-) battery terminal and check the power trunk module correctly. |
Inspection |
1. |
Check the power trunk module input/output value by using the
GDS. If the operation of power trunk module is abnormal, replace power
trunk drive unit. |
2. |
To check the DTC of the power trunk module, select "PTM" |
3. |
Select "Input/output monitoring". |
Components and Components Location
Component Location
1. Engine room junction box & FAM (Front Area Module)2. SJB (Smart Junction Box)3. Engine Room Fuse & relay box4. Passenger compartment relay box (RH)
...
MTS Antenna Components and Components Location
Components
...
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud,
sand, or similar hazards, follow these suggestions:
Drive cautiously and allow extra distance for braking.
...