>
Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear glass defogger relay (A) from the engine room relay box. |
3. |
There should be continuity between the No.87 and No.30
terminals when power and ground are connected to the No.86 and No.85 in
the relay. |
4. |
There should be no continuity between the No.87 and No.30 terminals when power is disconnected. |
ETC (Electronic Throttle Control) System Description and Operation
Description
The Electronic Throttle Control (ETC) System consists of a
throttle body with an integrated control motor and throttle position
sensor (TPS). Instead of the traditional throttle cab ...
Automatic heating and air conditioning
1. Press the AUTO button.
The modes, fan speeds, air intake and air-conditioning will be controlled automatically
according to the temperature setting.
2. Press the TEMP button to set the desi ...
Camshaft Position Sensor (CMPS) Troubleshooting
Signal Waveform
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...