>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A). |
3. |
Using a screwdriver or plastic panel remover, remove the center fascia upper panel (A). |
4. |
Disconnect the heater control unit connector (A), clock and SSB connector (B). |
5. |
After loosening the screws, remove the heater control unit (A) from the center fascia upper panel. |
Installation |
1. |
Install the heater control unit to the center fascia upper panel. |
2. |
Install the center fascia upper panel. |
3. |
Install the cluster fascia upper panel. |
Inspection |
1. |
Check IPM input/output specification of windshield deicer
switch using the GDS. If the specification is abnormal, replace the
windshield deicer switch module. |
2. |
Select option "Input/output monitoring". |
3. |
To check the input value of windshield deicer switch in force mode, select option "Actuation test". |
Rearview camera (If equipped)
The rearview camera will activate when the back-up light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind ...
Sunroof Glass Repair procedures
Replacement
•
Put on glove to protect your hands.
1.
Remove both sides of the decoration cover (A).
2.
Loosen the mounting screws, then remove the glass (A) by l ...
Memory Power Seat Switch Components and Components Location
Components
...