>
Inspection |
1. |
Remove the front door quadrant inner cover. Take care not to damage fixing clips.
(Refer to Body - "Front Door") |
2. |
Disconnect the power door mirror connector from the harness. |
3. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
Memory Mirror
Mirror Heater
Puddle Lamp
Turn Signal Lamp
BSD Warning Lamp
ECM Function
Folding Mirror |
TPMS Receiver Description and Operation
Description
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no Auto-Lo ...
Steering Wheel Remote Controller (SWRC) Schematic Diagrams
Circuit Diagram
...
Fuel Filler Cap Description and Operation
Description
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which would seal the fuel
filler. After the gasket on the fuel filler cap ...