>
Inspection |
1. |
The DDM inputs can be checked using the GDS. |
2. |
To check the input value of door lock switch, select option "IPM". |
3. |
Select option "DDM (Driver Door Module)". |
4. |
Select option "Input/Output monitoring". |
5. |
To check the input value of door lock switch in force mode, select option "ACTUATION TEST". |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim. (Refer to the Body group - "Front Door") |
3. |
Disconnect the DDM module connector (A). |
4. |
Remove the DDM module with power mirror switch after loosening the mounting screws. |
Installation |
1. |
Install the DDM module. |
2. |
Install the front door trim. |
Auto Defogging Sensor Repair procedures
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remov ...
Blower Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
3.
Separate the blower unit (A) from the heater un ...
Mode Control Actuator Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the
mode control actuator based on the signal of the A/C control unit. ...