>
Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Pull out the relay from the engine compartment relay box. |
|
1. |
There should be continuity between the No.30 and No.87
terminals when power and ground are connected to the No.85 and No.86
terminals. |
2. |
There should be no continuity between the No.30 and No.87 terminals when power is disconnected. |
1. |
There should be continuity between the No.30 and No.87
terminals when power and ground are connected to the No.85 and No.86
terminals. |
2. |
There should be no continuity between the No.30 and No.87 terminals when power is disconnected. |
1. |
There should be continuity between the No.30 and No.87
terminals when power and ground are connected to the No.85 and No.86
terminals. |
2. |
There should be continuity between the No.30 and No.87 terminals when power is disconnected.
A : ECU relay |
1. |
Be sure there is no play in the fuse holders, and that the fuses are held securely. |
2. |
Are the fuse capacities for each circuit correctx |
3. |
Are there any blown fusesx
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse. |
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench (A).
Tightening torque :
2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft)
...
Side repeater light bulb replacement (if equipped)
If the light bulb is not operating, have the vehicle checked by an authorized
EQUUS dealer. ...
Steering wheel audio control
The steering wheel may incorporate the audio control buttons.
CAUTION
Do not operate audio remote control buttons simultaneously.
VOLUME (VOL + / - ) (1)
Press the up button (+) to increase ...