>
Inspection |
1. |
Remove the trunk room left side trim. |
2. |
Open the fuel filler door and remove the housing.
(Refer to the BD group - "Exterior")
|
3. |
Remove the connector and bolts (2EA). |
4. |
Check for continuity between terminal No.1 and No.2. If there is no continuity replace the fuel filler door opener. |
Passenger Airbag (PAB) Module Components and Components Location
Components
...
Evaporator Temperature Sensor Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure the resistance between terminal “+” and “-” of the evaporator temperature ...
Damper Clutch Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...