>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front seat.
(Refer to Body - "Front Seat Assembly") |
3. |
Remove the front seat cushion cover.
(Refer to Body - "Front Seat Cushion Cover") |
4. |
Remove the blower fan (A) after removing the fixed clip (B) and screws. |
5. |
Remove the front seat back board.
(Refer to Body - "Front Seat Back Cover") |
6. |
Remove the TED (A) from the seat back and then loosen the screws. |
7. |
Disconnect the TED connector and then remove the duct. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front seat.
(Refer to Body - "Front Seat Assembly") |
3. |
Remove the climate control system seat unit (A) after disconnecting the connectors and loosening the screws. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear seat.
(Refer to Body - "Rear Seat Assembly") |
3. |
Remove the rear seat cushion.
(Refer to Body - "Rear Seat Cushion Cover") |
4. |
Remove the blower fan and the TED (B) after loosening the screws from the seat frame. |
5. |
Remove the rear seat back cover.
(Refer to Body - "Rear Seat Back Cover") |
6. |
Disconnect the connectors. |
7. |
Remove the blower fan (A) and the TED (B) after loosening the screws. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear seat.
(Refer to Body - "Rear Seat Assembly") |
3. |
Remove the climate control system seat unit (A) after disconnecting the connectors and loosening the screws. |
Installation |
1. |
Connect the connector and then install the TED and climate control system duct on the side of the seat back. |
2. |
Install the front seat back board. |
3. |
Install the blower fan by connecting it to the connector and fixed clip under the front seat cushion. |
4. |
Install the TED on the seat cushion. |
5. |
Install the front seat cushion. |
6. |
Install the front seat. |
7. |
Connect the negative (-) battery terminal. |
1. |
Install the climate control system seat unit after connecting the connectors. |
2. |
Install the front seat. |
3. |
Connect the negative (-) battery terminal. |
1. |
Install the blower fan and the TED on the side of rear seat back. |
2. |
Install the rear seat back. |
3. |
Install the blower fan and the TED under the rear seat cushion. |
4. |
Install the rear seat cushion, the duct and bracket. |
5. |
Install the rear seat. |
6. |
Connect the negative (-) battery terminal. |
1. |
Install the climate control system seat unit after connecting the connectors. |
2. |
Install the rear seat. |
3. |
Connect the negative (-) battery terminal. |
3 Zone control button
1. Press the 3 zone button to operate the front passenger's temperature, rear
side temperature, and rear side mode individually. The indicator on the 3 zone button
will be illuminated. Press ...
Engine Control Module (ECM) Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutra ...
Side Sill Molding Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...