>
Inspection |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover") |
3. |
Disconnect the power seat air lumber support switch connector (A). |
4. |
With the power seat air lumber support switch in each position, make sure that continuity exists between the terminal below.
If continuity is not as specified, replace the switch.
|
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the seat back cover.
(Refer to Body - "Front Seat Back Cover") |
3. |
Disconnect the air lumber tripple valve unit connector.
|
4. |
With supplying the voltage to the air pump in each position, check that the air lumber support is operated properly.
|
Interior light bulb replacement
1. Using a flat-blade screwdriver, gently pry the lens from the interior light
housing.
2. Remove the bulb by pulling it straight out.
WARNING
Prior to working on the Interior Lights, ensure th ...
Front Disc Brake Components and Components Location
Components
1. Caliper body2. Guide pin3. Locking pin4. Brake pad5. Pad shim6. Retraction spring7. Bleed screw
...
Rear Variable Damper Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Disconnect the rear shock absorber (A) from the rear axle by loo ...