>
Inspection |
1. |
Disconnect the limit switch (A) and operate the limit switch. |
2. |
Check for continuity between the terminals. |
3. |
Make sure that the seat operation is normal in the reverse after the maximum operation. |
4. |
If there is an abnormality, replace the limit switch. |
1. |
Disconnect the limit switch and operate the limit switch. |
2. |
Check for continuity between the terminals. |
3. |
Make sure that the seat operation is normal in the reverse after the maximum operation. |
4. |
If there is an abnormality, replace the limit switch. |
1. |
Disconnect the connectors for each motor. |
2. |
With the battery connected directly to the motor terminals, check if the motors run smoothly. |
3. |
Reverse the connections and check that the motor turns in reverse. |
4. |
If there is an abnormality, replace the motors.
[Driver (IMS)]
[Assist (Limousine 5:5 Option)]
[Assist (Except For Limousine 5:5 Option)]
[Rear Assist] |
Fuel Pump Control Module (FPCM) Specifications
Specification
ltemSpecificationSupply Voltage (V)8~18Supply Current (A)Max. 10Fuel Pressure (kpa)Starting600Drive350 ~ 500Stop20 Under
...
Owner’s responsibility
✽ NOTICE
Maintenance Service and Record Retention are the owner's responsibility.
You should retain documents that show proper maintenance has been performed on
your vehicle in accordan ...
Front Seat Shield Inner Cover Components and Components Location
Component Location
1. Front seat shield inner cover
...