Hyundai Equus: Body Control Module (BCM) Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body Electrical System / BCM (Body Control Module) / Body Control Module (BCM) Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body Electrical System / BCM (Body Control Module) / Body Control Module (BCM) Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Disconnect the connector, bolt and nuts from smart key unit, BCM and tilt & telescopic unit.
|
| 4. |
Remove the smart key (A) and BCM unit (B) after loosening bolt and nuts.
|
| Installation |
| 1. |
Install the smart key unit and BCM unit and then connect the connectors. |
| 2. |
Install the crash pad lower panel. |
| 3. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
The body control module can diagnose by using the GDS more quickly.
The BCM communicates with the GDS and then reads the input/output value and drives the actuator. |
| 2. |
To diagnose the BCM function, select the menu of model and body control module.
|
| 3. |
Select "Input/output monitoring", if you will check current
data of body network system. It provides input/output status of each
module.
|
| 4. |
If you will check each module data operation forcefully, select "Actuation test".
|
| 5. |
If you want to change user option, select “user option”.
|
Description and Operation
Description
Communication Network Diagram
AbbreviationExplanationC_CANChassis Controller Area NetworkB_CANBody Controller Area NetworkMM_CANMulti media Controller Area NetworkSMKSmart Key UnitDD ...
See also:
Rear Stabilizer Bar Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...
Schematic Diagrams
System Diagram
1. Front view camera2. PGS Unit3. AVN monitor (LCD)4. Front blind camera switch5. Rear view camera
Block Diagram & Communications
CategoryRoleVoltageI/OIgnition Power· Ro ...
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Disconnect the accelerator control ...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com