>
Components |
No. | Connector A | Connector B | Connector C |
1 | V_BAT load | C_CAN Low | SSB illumination ground |
2 | - | C_CAN High | - |
3 | Power ground1 | - | SSB LED OFF |
4 | IGN1 | - | Interior antenna #2 power |
5 | IGN1 relay | Brake switch | Interior antenna #1 power |
6 | ACC | Immobilizer antenna power | - |
7 | IGN2 | - | Interior antenna #3 (hat shelf) |
8 | SSB switch2 | Wheel speed | Interior antenna #4 (Trunk) |
9 | RDRV toggle button | Driver toggle button | Bumper antenna power |
10 | RF COM | - | Passenger side antenna power |
11 | - | - | Driver side antenna power |
12 | B_CAN High | P position/ Clutch switch | SSB LED IGN |
13 | B_CAN Low | Start feedback | SSB illumination power |
14 | V_BAT CPU | Immobilizer antenna ground | - |
15 | - | - | Interior antenna #2 ground |
16 | Power ground2 | SSB LED ACC | Interior antenna #1 ground |
17 | Starter relay | x | - |
18 | IGN2 relay | Interior antenna #3 (hat shelf) power | |
19 | ACC relay | Interior antenna #3 (Trunk) power | |
20 | - | Bumper antenna ground | |
21 | - | Passenger side antenna ground | |
22 | RAST toggle button | Driver side antenna ground | |
23 | RPM | x | |
24 | EMS COM | ||
25 | SSB switch1 | ||
26 | Assistant toggle button |
Parking Assist Sensor Repair procedures
Removal
[Front Bumper]
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector from the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Pull out the se ...
Check battery and cables
Winter puts additional burdens on the battery system. Visually inspect the battery
and cables as described in section 7. The level of charge in your battery can be
checked by an authorized EQUUS d ...
Rear Right Door Module (RRDM) Description and Operation
Description
1.
Rear Right Power Window Switch
(1)
Main features
ItemExplanationInstallation positon Rear Right Door TrimComponent configuration
1.
Embedded with LIN Communication IC
2.
...