>
Smart Key |
1. |
Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. |
2. |
Remove the battery (A) and check voltage if the red light doesn't flicker.
(Refer to Owner's manual - "Battery Replacement")
[Standard]
[Card] |
3. |
Insert the battery (A) into the tester (09954-2P100). |
4. |
Push the test button and If "0.00" is displayed on screen, it means that the battery voltage is 2V or less. |
5. |
If "L" is displayed on screen, it means that the battery is low power and it needs to replace. |
6. |
To prevent the discharge of electricity, turn the tester power off. |
7. |
Replace the transmitter battery with a new one, if voltage is
low power then try to lock and unlock the doors with the transmitter by
pressing the lock or unlock button five or six times. |
8. |
If the doors lock and unlock, the transmitter is O.K, but if
the doors don't lock and unlock, register the transmitter code, then try
to lock and unlock the doors. |
9. |
If the doors lock and unlock, the transmitter is O.K, but if the doors don't lock and unlock, replace the transmitter.
|
1. |
Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. |
2. |
Select the vehicle model and then do "Smart key code saving". |
3. |
After selecting "Smart key teaching" menu, push "Enter" key, then the screen will be shown as below. |
4. |
After having the teaching smart key, push "ENTER" key. |
5. |
Input the "Pin code" for first key teaching. |
6. |
Press the SSB with smart key within 5 sec after pressing "OK". |
7. |
Confirm the message "First key teaching completed". |
8. |
Press the SSB with smart key within 5 sec after pressing "OK". |
9. |
Confirm the message "Second key teaching completed". |
10. |
Then the screen will be shown as below when key teaching process is completed. |
Automatic-dimming function
Your mirror will automatically dim upon detecting glare from the vehicles traveling
behind you. The autodimming function can be controlled by the Dimming ON/OFF Button:
1. Pressing the button turn ...
Troubleshooting
Troubleshooting
•
The battery must be in good condition and fully charged for this troubleshooting.
...
Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory
to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels al ...