>
Removal |
1. |
Remove the steering column upper and lower shrouds after loosening screws. |
2. |
Disconnect the multifunction switch connector (A). |
3. |
Remove the wiper & washer switch (A) by pushing the lock pin.
|
4. |
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring") |
5. |
Loosen the screws (2EA) from the multifunction switch assembly (A). |
Installation |
1. |
Install the multifunction switch after connecting the connector. |
2. |
Install the clock spring.
|
3. |
Install the steering column upper and lower shrouds. |
4. |
Install the steering wheel.
|
Inspection |
1. |
Check input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp or
wiper switch. |
2. |
If diagnosis is required on the multifunction switch, select model and "BCM". |
3. |
Select "Current data" and check the input/output condition of "Multifunction switch". |
Front passenger’s seat
(8) Seat sliding forward or backward Seat height and cushion tilting adjustment
(9) Seatback angle adjustment
(10) Headrest height adjustment
(11) Climate control system seat
Rear seat
(12) Seat ...
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
Front LCD monitor Components and Components Location
Components
...