>
Replacement |
|
|
1. |
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly") |
2. |
Remove the front seat rear shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover") |
3. |
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover") |
4. |
Disconnect the front seat under lamp connector (A). |
5. |
Pull out the protecter (A), and then front seat cushion cover (C) from the front seat cushion frame (B). |
6. |
Remove the front seat cushion cover (A) from the front seat cushion frame. |
7. |
After removing the hog-ring clips on the front of seat cushion and remove the front seat cushion cover (A). |
8. |
Install in the reverse order of removal.
|
Detecting sensor
The sensors are located inside of the rear bumper.
Always keep the rear bumper clean for the system to work properly. ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Front Door Module Components and Components Location
Component Location
1. Front door module
...