>

Hyundai Equus: Rear Bumper Beam Assembly Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")

2.	Disconnect the bumper antenna connector (A).

3.	Disconnect the rear bumper joint connector mounting clip (A).

4.	Remove the mounting clips (B), then remove the rear bumper beam assembly (A) and then loosen the clips.

5.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damage clips.

Rear Bumper Beam Assembly Components and Components Location

Component Location 1. Rear bumper beam assembly ...

Front Seat

...

See also:

Ignition Coil Description and Operation
Description An ignition coil is an induction coil in an engine's ignition system which transforms the battery's low voltage to the high voltage needed to create an electric spark in the spark p ...

Emergency towing
If towing is necessary, we recommend you to have it done by an authorized EQUUS dealer or a commercial tow truck service. If towing service is not available in an emergency, your vehicle may be t ...

Rear Glass Defogger Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A). 3. Using a screwdriver or plastic panel ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com