>

Hyundai Equus: Crash Pad Lower Panel Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

2.	After loosening the mounting screws, then remove the crash pad lower panel (A).

3.	Disconnect the crash pad lower panel switch connector (A) and knee airbag (KAB) module connector (B).

4.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damage clips.

Crash Pad Lower Panel Components and Components Location

Component Location 1. Crash pad lower panel ...

Glove Box Housing Components and Components Location

Component Location 1. Glove box housing ...

See also:

Repair procedures
Inspection Relex Power Seat Module (RPSM) For Passenger & Rear Glossary - RPSM : Relax Power Seat Module - Combined RELAX SW : Combined RELAX SWITCH - Combined WALK IN SW : Combin ...

Fuel requirements
Your new vehicle is designed to obtain maximum performance with UNLEADED FUEL, as well as minimize exhaust emissions and spark plug fouling. Your new vehicle is designed to use only unleaded fuel h ...

How does the air bag system operate
Air bags are activated (able to inflate if necessary) only when the Engine Start/Stop Button is turned to the ON or START position. Air bags inflate in the event of a severe frontal or side co ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com