>

Hyundai Equus: Rear Console Cover Repair procedures - Floor Console - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Rear Console Cover Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console armrest.
(Refer to Floor Console - "Front Console Armrest")
2.
Loosen the mounting screws (A) located in the top of the rear console cover.

3.
Disconnect the connectors (A).

4.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Replace any damage clips.
    Rear Console Cover Components and Components Location
    Component Location 1. Rear console cover ...

    Console Armrest Components and Components Location
    Component Location [Front Console Armrest] 1. Front console armrest [Rear Console Armrest] 1. Rear console armrest ...

    See also:

    Cylinder Block Repair procedures
    Disassembly Engine removal is required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors ca ...

    To keep locks from freezing
    To keep the locks from freezing, squirt an approved de-icer fluid or glycerine into the key opening. If a lock is covered with ice, squirt it with an approved de-icing fluid to remove the ice. If ...

    Operating Door Locks From Inside the Vehicle
    With the Door Lock Button : To unlock a door, push the door lock button (1) to the “Unlock” position. The red mark (2) on the door lock button will be visible. To lock a door, push the door ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com