• |
Put on gloves to protect your hands. |
|
• |
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. |
• |
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. |
• |
Take care not to bend or scratch the trim and panels. |
|
1. |
Using a screwdriver or remover, remove the gear boots (B). |
2. |
To remove the gear knob (A) and gear boots (B) pull both of it up. |
3. |
Using a screwdriver or remover, remove the front console upper cover (A). |
4. |
Disconnect the connectors (A). |
5. |
Using a screwdriver or remover, remove the console side cover (A).
[LH]
[RH] |
6. |
Disconnect the floor console main connector (A). |
7. |
Remove the console armrest tray (A). |
8. |
Remove the console armrest service cover (A). |
9. |
After loosening the mounting screws and bolts, then remove the floor console assembly (A). |
10. |
Install in the reverse order of removal.
• |
Make sure the connector is connected properly. |
• |
Replace any damage clips. |
|
|
1. |
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
2. |
Disconnect the connectors (A). |
4. |
After loosening the mounting bolts, remove the rear tower console complete assembly (C). |
5. |
Remove the nozzle assembly (A). |
6. |
Disconnect the connectors (A). |
7. |
After loosening the mounting bolts, remove the rear floor console complete assembly (A). |
8. |
Install in the reverse order of removal.
• |
Make sure the connector is connected properly. |
• |
Replace any damage clips. |
|
|
Component Location
1. Floor console assembly
...
Component Location
1. Rear console cover
...