>
Hyundai Equus Manuals

Hyundai Equus: Repair procedures - Sunroof - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Sunroof / Repair procedures

Adjustment
Inspect Sunroof Alignment
1.
Adjust the difference between the height of the glass roof panel (A) and glass weatherstrip (B).
Standard value [mm(in.)] :
Front edge : - 0.2 (- 0.0079)
Rear edge : ±0.2 (±0.0079)
Side edge : ±0.4 (±0.0157)

2.
Loosen the front screw and rear screw (A), adjust the height between the glass panel and roof panel.
Tightening torque :
2.0 ~ 3.9 N.m (0.2 ~ 0.4 kgf.m, 1.4 ~ 2.9 lb-ft)

Operating The Sunroof Emergency Handle
1.
Use the sunroof emergency handle to close or open the sunroof manually if the sunroof cannot be closed electronically due to motor or controller electrical malfunction.
2.
Operating method.
A.
Remove the roof trim.
B.
Push the emergency handle up into the hexagonal drive (A) of the sunroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
C.
Carefully turn the emergency handle clockwise to close the sunroof.
D.
After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
E.
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle.
   
•
Do not use power tools to operate the sunroof.
•
Damage to the components may occur.

    Components and Components Location
    Components 1. Glass panel2. Decoration cover3. Drip link4. Guide assembly5. Drip rail6. Sunshade7. Defector8. Defector link 9. Seal tape10. Motor11. Frame12. Set plate ...

    Sunroof Glass Components and Components Location
    Component Location 1. Sunroof glass ...

    See also:

    System operation
    Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed contro ...

    Starter Repair procedures
    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the starter cable (A) from the B terminal on the solenoid, and the connector (B) from the S ter ...

    Start/Stop Button Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center panel. (Refer to Body - "Crash Pad Center Panel") 3. Remove the start/stop button connector (A) fro ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com