>

Hyundai Equus: Roof Side Molding Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.

Using a screwdriver or remover, remove the roof side molding (A).

•	Always replace the roof side molding to a new one.

2.

Install in the reverse order of removal.

•	Replace any damaged clips.

Body Side Molding

...

Front Wheel Guard Repair procedures

Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

See also:

Heated Oxygen Sensor (HO2S) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 3 and 4. 4. Check that the resistance is within the speci ...

Components and Components Location
Component Location 1. Engine room junction box & FAM (Front Area Module)2. SJB (Smart Junction Box)3. Engine Room Fuse & relay box4. Passenger compartment relay box (RH) ...

Troubleshooting
Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at high ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com