>
Adjustment |
|
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
2. |
Carefully adjust the glass (A) until you can see the screws,
then loosen them. Separate the glass from the glass run and carefully
pull the glass out through the window slot. |
3. |
Check that the glass moves smoothly. |
|
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment. |
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches
properly, tighten the screws and recheck. |
|
1. |
Check that the door and body edges are parallel. |
2. |
Place the vehicle on a firm, level surface when adjusting the doors. |
3. |
Adjust at the hinges (A):
|
4. |
Grease the pivot portions of the hinges indicated by the arrows. |
5. |
Check for water leaks. |
Instrument panel overview
1. Instrument cluster
2. Lighting control lever
3. Wiper and washer control lever
4. Horn
5. Driver’s front air bag
6. Engine Start/Stop Button
7. Hazard warning flasher
8. Climate control sy ...
Cup holder
WARNING - Hot liquids
Do not place uncovered cups of hot liquid in the cup holder while the
vehicle is in motion. If the hot liquid spills, you could be burned. Such a
burn to the driver cou ...
Troubleshooting
Troubleshooting
SymptomSuspect areaEngine will not start or stuggle to startVapor hose damaged or disconnectedEngine stuggle to startMalfunction of the Purge Control Solenoid ValveRough idle or e ...