>
Removal |
1. |
Turn ignition switch off and disconnect the battery (-) cable from the battery |
2. |
Remove the driver side crash pad side cover.
(Refer to Body - "Crash Pad") |
3. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad") |
4. |
Remove the EPB switch after removing 4 screws from the crash pad lower panel. |
Inspection |
1. |
Measure resistance between EPB switch terminals as below. |
1. |
Measure resistance between Auto Hold switch terminals as below. |
Installation |
1. |
Install EPB switch assembly. |
2. |
Connect the crash pad switch assembly connector to EPB switch. |
3. |
Install the crash pad lower panel.
(Refer to Body - "Crash Pad") |
4. |
Install the driver side crash pad side cover.
(Refer to Body - "Crash Pad") |
Glove Box Housing Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protec ...
4&OD Clutch Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Jack and tools
The jack, jack handle, and wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
...