>

Hyundai Equus: Engine Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Engine Electrical System

Muffler Repair procedures
Removal 1. Disconnect the rear oxygen sensor (HO2S) connector (A) on LH and RH side. 2. Remove the front muffler (A) on LH and RH side. Tightening torque : 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m ...

General Information
...

See also:

Drive shafts and boots
Check the drive shafts, boots and clamps for cracks, deterioration, or damage. Replace any damaged parts and, if necessary, repack the grease. ...

Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input / Output signal ECM Harness Connector ECM Terminal Function Connector [C200-A] Pin No.DescriptionConnected to1Ignition Coil (Cylinder #3) control outputIgnition Coil ( ...

Camshaft Position Sensor (CMPS) Troubleshooting
Signal Waveform This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...

Categories

Hyundai Equus Manuals

© 2011-2026 Copyright www.heqmanual.com