>
Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Remove the ECTS (Refer to "Removal"). |
3. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the engine coolant temperature sensor connector (A), and then remove the engine coolant temperature sensor (B). |
3. |
Supplement the engine coolant (Refer to “Cooling System” in EM group).
|
Installation |
|
|
|
1. |
Install in the reverse order of removal.
|
Warning message
If the detecting sensor performance is low or overheated by foreign substances
on the rear bumper, the message will appear to notify the driver.
Also, the message may appear when there is heavy ...
Description and Operation
Description
Power Trunk Lid (PTL) System : It is automatically opens and
closes a vehicle’s trunk lid and cinches the latch with the press of a
button, and also can be easily operated, using an ...
PGS Unit (Back & Blinde Unit) Components and Components Location
Components
...