>
Removal |
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
3. |
Remove the front seat outer shield cover.
(Refer to Body - "Front Seat Outer Shield Cover") |
4. |
Disconnect the EFD system connector. |
5. |
Unscrew the mounting bolt from the front seat assembly, and then remove the EFD system (A). |
Installation |
1. |
Disconnect the negative (-) cable from battery and wait for at least three minutes. |
2. |
Install the EFD system with the mounting bolt.
|
3. |
Connect the EFD system connector. |
4. |
Install the front seat shield outer cover.
(Refer to Body - "Front Seat Outer Shield Cover") |
5. |
Install the front seat assembly.
(Refer to Body - "Front seat assembly")
|
6. |
Reconnect the battery negative cable. |
7. |
After installing the EFD system, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Auto Light Sensor Repair procedures
Inspection
In the state of IGN1 ON, when the multi function switch
module detects auto light switch on, tail lamp relay output and head
lamp low relay output are controlled according to auto li ...
Repair procedures
On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test
1.
Check for DTCs.
•
If a DTC is present, perform troubleshooting in accordance with the pr ...
GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front
or rear). These numbers are shown on the certification label. The total load on
each axle must never exceed its GAW ...