>
Warning Lamp Activation |
Warning Lamp Behavior after Ignition On |
1. |
Active fault or historical fault counter is greater or equal to 10. |
2. |
Normal or historical fault counter is less than 10. |
3. |
When turning the ignition switch ON during variant coding
(EOL) mode, the airbag warning lamp is turned on and blinks at intervals
of 1 second till the coding is completed.
In case the variant coding is normally completed, the airbag
warning lamp is turned on for 6 seconds, and then turned off. Otherwise
the airbag warning lamp continuously blinks at intervals of 1 second.
When there is active fault in the airbag system or SRSCM
internal fault, the variant coding (EOL) cannot be completed. In this
case, do the variant coding (EOL) procedure again after troubleshooting
with the GDS. |
1. |
Loss of battery supply to the SRSCM : warning lamp is turned on continuously. |
2. |
Loss of internal operating voltage : warning lamp is turned on continuously. |
3. |
Loss of microprocessor operation : warning lamp is turned on continuously. |
4. |
SRSCM not connected : warning lamp is turned on continuously. |
Occupant Status | Telltale Lamp | PAB |
Empty | ON | Disabled |
Child (Small Occupant) | ON | Disabled |
Adult (Large Occupant) | OFF | Enabled |
Defect | OFF | Enabled |
Easy Access Function
When exiting the vehicle, the steering wheel will move away from the driver and
the seat will move rearward when the engine is turned off.
When entering the vehicle, the steering wheel will move to ...
Specifications
Specifications
DescriptionSpecificationsLimitGeneralTypeV-type, DOHCNumber of cylinders8Bore96mm (3.7795in)Stroke87mm (3.4252in)Total displacement5.038 cc (307.3 cu.in)Compression ratio11.5 : 1Fi ...
Consumer information
This consumer information has been prepared in accordance with regulations issued
by the National Highway Traffic Safety Administration of the U.S. Department of
Transportation.
Your EQUUS dealer ...