In the state of IGN1 ON, when the multi function switch
module detects auto light switch on, tail lamp relay output and head
lamp low relay output are controlled according to the vertical and
horizontal auto light sensor's input.
If IGN1 ON, The BCM monitors the range of this supply and
raises up a failure as soon as the supply’s voltage is out of range.
Then this failure occurs and as long as this is present, the head lamp
must be turned on without taking care about the sunlight level provided
by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during the night.
Component Location
1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. IPM (Instrument Panel Module)
...
Inspection
In the state of IGN1 ON, when the multi function switch
module detects auto light switch on, tail lamp relay output and head
lamp low relay output are controlled according to auto li ...
See also:
Special Service Tools
Special Service Tools
Tool (Number and name)IllustrationUseCrankshaft front oil seal installer(09231-2J310)(09231-H1100)Installation of the front oil sealRing gear stopper(09231-2B100)(09231-3N10 ...
Glove Box Housing Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protec ...
If you have a flat tire while driving
If a tire goes flat while you are driving:
1.Take your foot off the accelerator pedal and let the car slow down while driving
straight ahead. Do not apply the brakes immediately or attempt to pull ...