>
Removal |
1. |
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. |
2. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly") |
3. |
Disconnect the curtain airbag harness connector. |
4. |
After loosening the mounting bolts remove the curtain airbag. |
Installation |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable and wait for at least three minutes. |
3. |
Tighten the curtain airbag mounting bolts.
|
4. |
Connect the curtain airbag connector. |
5. |
Install the roof trim assembly.
(Refer to Body - "Roof Trim Assembly") |
6. |
Reconnect the battery negative cable. |
7. |
After installing the curtain airbag (CAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Electric Parking Brake (EPB) Repair procedures
Removal
1.
Release the parking brake by pushing the EPB switch.
2.
Turn ignition switch off and disconnect the battery (-) cable from the battery.
3.
Remove the canister service cover in ...
Power Latch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk")
3.
Remove the power latch (A) after removing the bolts (2EA) and ...
Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 7,500
miles (12,000 km) or sooner if irregular wear develops.
During rotation, check the tires for correct balance.
When r ...