>

Hyundai Equus: Crankshaft Position Sensor (CKPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Crankshaft Position Sensor (CKPS) Repair procedures

Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.

Specification: Refer to “Waveform�

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A).

3.
Remove the sensor (B) after removing the installation bolt (A).

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the engine oil to the O-ring.
   
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Install in the reverse order of removal.

Crankshaft position sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Crankshaft Position Sensor (CKPS) Schematic Diagrams
    Circuit Diagram ...

    Camshaft Position Sensor (CMPS) Description and Operation
    Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

    See also:

    Cowl Cross Bar Assembly Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Intake Manifold Components and Components Location
    Components 1. Purge control solenoid valve (PCSV) and hose2. PCV hose3. ETC module4. Intake manifold module5. MAP sensor ...

    Front Hub / Knuckle / Tone Wheel Components and Components Location
    Component location 1. Front knuckle assembly2. Hub assembly3. Dust cover4. Brake disc ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com