>
Removal |
|
1. |
Removal the front bumper.
(Refer to Body - "Front bumper") |
2. |
Removal the left head amp.
(Refer to Body Electrical System - "Head lamp leveling device") |
3. |
Removal the EHPS motor.
(Refer to Steering System - "Power steering motor") |
4. |
Disconnect the connector (A) & air hose (B).
|
5. |
Remove the bracket bolt. |
6. |
Disconnect the solenoid valve (A) from the compressor by loosening the bolt. |
7. |
Installation is the reverse of removal.
|
Components and Components Location
Components
1. Cowl side trim2. Front door scuff trim3. Center pillar lower trim4. Rear door scuff trim5. Rear pillar trim6. Rear wheel house trim7. Rear package tray trim 8. Front pillar trim
...
Trunk Lid Assembly Components and Components Location
Component Location
1. Trunk lid assembly
...
Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECT ...