>
Adjustment |
1. |
Driving the vehicle in a circle at less than 8km/h 3 times or until the compass heading appears. |
2. |
Driving in a circle in right-handed direction and opposite
direction are possible, and if the calibration is completed, the compass
heading will appear. |
3. |
Keep driving in a circle until a commpass heading appears. |
1. |
Determine the desired zone number based upon your current location on the zone maps. |
2. |
Press and hold the Feature Control button for more than 6 but
less than 9 seconds, the current zone number will appear on the display
(B). |
3. |
Pressing and holding the feature control button (A) again
will cause the numbers to increment (Note: they will repeat …13, 14,
15, 1, 2,..). Releasing the button when the desired zone number appears
on the display will set the new zone. |
4. |
Within about 5 seconds the compass will start displaying a compass heading again. |
1. |
Press and hold the feature control button (A) for more than 9
seconds. When the compass memory is cleared, a "C" will appear in the
display (B). |
2. |
To calibrate the compass, drive the vehicle is 2 complete circles at less than 8 KPH (5 MPH). |
Filter replacement
1. With the glove box open, remove the stoppers on both sides to allow the glove
box to hang freely on the hinges.
2. Remove the cylinder at the left of the glove box.
3. Remove the cl ...
Input Speed Sensor Description and Operation
Description
Input speed sensor is a vital unit that measures the rate of
rotation of the input shaft inside the transmission and delivers the
readings to the TCM. The sensor provides critical ...
System operation
Ventilation
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed contro ...