>
Inspection |
1. |
Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch.
* For diagnostic procedure, refer to DTC guide.
|
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim") |
3. |
Remove the crash pad under cover (A) by pressing the locking pin. |
4. |
Disconnect the under lamp connector (A). |
5. |
Remove the stopper (B) from the glove box (A). |
6. |
Disconnect the air damper (A) from the glove box (B). |
7. |
Remove the glove box housing (A) after loosening the mounting screws and nuts. |
8. |
Disconnect the glove box lamp connector (A). |
9. |
Disconnect the evaporator temperature sensor connector, and then remove the cluster ion generator (A). |
10. |
Install in the reverse order of removal. |
Front Seat Frame Assembly Components and Components Location
Component Location
1. Front seat back frame assembly2. Front seat cushion frame assembly
...
Engine coolant
The high-pressure cooling system has a reservoir filled with year-round antifreeze
coolant. The reservoir is filled at the factory.
Check the antifreeze protection and coolant level at least once a ...
Schematic Diagrams
Circuit Diagram
...