>
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake fluid, clean the area around the reservoir cap thoroughly to prevent brake fluid contamination.
If the level is low, add fluid to the MAX level. The level will fall with accumulated mileage. This is a normal condition associated with the wear of the brake linings. If the fluid level is excessively low, have the brake system checked by an authorized EQUUS dealer.
Use only the specified brake fluid. (Refer to “Recommended lubricants or capacities” in section 8.)
Never mix different types of fluid.
WARNING - Loss of brake fluid
In the event the brake system requires frequent additions of fluid, the vehicle should be inspected by an authorized EQUUS dealer.
WARNING - Brake fluid
When changing and adding brake fluid, handle it carefully. Do not let it come in contact with your eyes. If brake fluid should come in contact with your eyes, immediately flush them with a large quantity of fresh tap water. Have your eyes examined by a doctor as soon as possible.
CAUTION
Do not allow brake fluid to contact the vehicle's body paint, as paint damage will result. Brake fluid, which has been exposed to open air for an extended time should never be used as its quality cannot be guaranteed. It should be disposed of properly. Don't put in the wrong kind of fluid. A few drops of mineralbased oil, such as engine oil, in your brake system can damage brake system parts.
Components and Components Location
Components Location
1. Fuel tank2. Fuel pump3. Sub fuel sender4. Fuel filter5. Over Pressure Valve (OPV)6. Canister7. Fuel tank air filter8. Fuel Pressure Sensor (FPS)9. Fuel Level Sensor ( ...
Limousine Under Body
Under body
Projected dimensions
Tooling hole (O25)Front sub frame mounting pipe (O25)Tooling hole (O14)Front sub frame mounting pipe (O27)Tooling hole (O15)Tooling & paint drain hole (O6.6 ...
Spark plugs
Make sure to install new spark plugs of the correct heat range. ...