>
Removal |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the service cover (A). |
3. |
Disconnect the fuel tank pressure sensor connector (A) and the canister close valve connector (B). |
4. |
Disconnect the vapor tube quick-connector (C), the vapor hose quick-connector (D), and the vapor hose (E) from the canister. |
5. |
Remove the fuel tank pressure sensor hose clip (F). |
6. |
Remove the canister after removing the installation bolt (G). |
Inspection |
1. |
Check for the following items visually.
A: Canister - Atmosphere (via Fuel Tank Air Filter)
B: Canister - Fuel Tank
C: Canister - Intake Manifold
|
Installation |
Canister installation bolt :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~4.3 lb-ft)
Canister cover installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~8.7 lb-ft)
Canister protector installation bolt :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~21.7 lb-ft) |
Crash Pad Under Cover Repair procedures
Replacement
[LH]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply ...
Special Service Tools
Special Service Tools
Tool (Number and Name)IllustrationUse09561-11001Steering wheel pullerRemoval of steering wheel
...
Repair procedures
Compression Pressure Inspection
If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.
Warm up engine to norma ...