>
Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the CCV connector. |
3. |
Measure resistance between the CCV terminal 1 and 2. |
4. |
Check that the resistance is within the specification.
|
5. |
Disconnect the vapor hose connected with the canister from the CCV. |
6. |
Connect a vacuum pump to the nipple. |
7. |
Ground the CCV control line and apply battery voltage to the CCV power supply line. |
8. |
Apply vacuum and check the valve operation.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the service cover (A). |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the vapor hose (B) from the canister. |
5. |
Remove the installation bolt. |
6. |
Remove the canister close valve from the fuel tank air filter. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Climate control system
1. Driver’s temperature control knob
2. Front windshield defrost button
3. Rear window defrost button
4. AUTO (automatic control) button
5. Fan speed control button
6. OFF button
7. Air intake ...
Sunvisor Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Use ...
Jack and tools
The jack, jack handle, and wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
...