>

Hyundai Equus: Brake Pedal Components and Components Location - Brake System - Brake System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Brake Pedal Components and Components Location

Components

1. Brake pedal member assembly
2. Stop lamp switch
3. Clevis pin
4. Snap pin
5. Brake pedal
6. Return spring
7. Bolt

    Brake Line Repair procedures
    Removal 1. Remove the wheel & tire. 2. Remove the brake hose clip (A). Front Rear 3. Disconnect the brake tube by loosening the tube flare nut. Tightening torque : 12.7 ~ 16.7 N ...

    Brake Pedal Repair procedures
    Removal 1. Remove the lower crash pad. (Refer to Body - "Crash Pad") 2. Disconnect the stop lamp switch connector (A). 3. Remove the mounting bracket nut (B). Tightening torque : 14. ...

    See also:

    Repair procedures
    On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.     • If a DTC is present, perform troubleshooting in accordance with the pr ...

    Trunk Lid Latch Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protec ...

    Mode Control Actuator Description and Operation
    Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com