>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Disconnect the connector, bolt and nuts from smart key unit, BCM and tilt & telescopic unit. |
4. |
Remove the smart key (A) and BCM unit (B) after loosening bolt and nuts. |
Installation |
1. |
Install the smart key unit and BCM unit and then connect the connectors. |
2. |
Install the crash pad lower panel. |
3. |
Connect the negative (-) battery terminal. |
Inspection |
1. |
The body control module can diagnose by using the GDS more quickly.
The BCM communicates with the GDS and then reads the input/output value and drives the actuator. |
2. |
To diagnose the BCM function, select the menu of model and body control module. |
3. |
Select "Input/output monitoring", if you will check current
data of body network system. It provides input/output status of each
module. |
4. |
If you will check each module data operation forcefully, select "Actuation test". |
5. |
If you want to change user option, select “user option”. |
Light bulbs
WARNING - Working on the lights
Prior to working on the light, firmly apply the parking brake, ensure that
the ignition switch is turned to the LOCK position and turn off the lights to avoid
sudd ...
Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON’T remove the camshaft position se ...
Rain Sensor Schematic Diagrams
Circuit Diagram
...