>
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit") |
3. |
Separate the blower unit (A) from the heater unit (B) after loosening the screws. |
4. |
Install in the reverse order of removal. |
Starter Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the starter cable (A) from the B terminal on the solenoid, and the connector (B) from the S ter ...
Components and Components Location
Components
1. ESP control module (HECU)2. Steering angle sensor3. Rear wheel speed sensor4. Sensor cluster (Yaw rate & Lateral)5. Front wheel speed sensor
...
Heater Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
When the engine is cool, drain the engine coolant fro ...