>
Inspection |
1. |
Connect the battery voltage and check the blower motor rotation. |
2. |
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation. |
3. |
Replace the blower motor if it is proved that there is a problem with it.
|
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim") |
3. |
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down. |
4. |
Disconnect the under lamp connector (A). |
5. |
Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws. |
6. |
Install in the reverse order of removal. |
Components and Components Location
Components Location
1. Front strut assembly2. Front brake disc3. Tie rod end assembly4. Front sub frame5. Tension arm6. Lateral arm7. Front knuckle assembly
...
Rear Stabilizer Bar Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...
Blind Spot Detection Unit Repair procedures
Removal
Blind spot detection (BSD) unit
1.
Disconnect the negative (-) battery.
Be careful when removing the blind spot detection unit. The bracket may break off from the b ...