>
Removal |
1. |
Disconnect the negative (-) battery. |
2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the crash pad lower panel and then push the blind spot detection switch (A) to remove it.
|
Installation |
1. |
Install the blind spot detection switch after connecting the connector. |
2. |
Install the crash pad lower panel. |
Inspection |
1. |
Disconnect the BSD switch connector. |
2. |
Operate the BSD switch, then check for continuity between terminals of BSD switch connector. |
Specifications
Specifications
ItemSpecificationSteering GearTypeRack & PinionRack strokeManual144mmAIR136mmPower Steering MotorTypeBLDC (WET type)Voltage13.5VSteering angle (Max.)InnerR17Manual42.67°±1°30’A ...
Side repeater light bulb replacement (if equipped)
If the light bulb is not operating, have the vehicle checked by an authorized
EQUUS dealer. ...
Trunk Lid Assembly Components and Components Location
Component Location
1. Trunk lid assembly
...