>

Hyundai Equus: Blind Spot Detection Indicator Repair procedures - Blind Spot Detecation system - Body Electrical System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Blind Spot Detection Indicator Repair procedures

Removal
Blind Spot Detection Warnig Indicator
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirro (A).

Installation
Blind Spot Detection Warnig Indicator
1.
Install the outside mirror.
2.
Connect the negative (-) battery terminal.
Inspection
1.
Verify that the mirror operates properly as shown in the below table.

BSD warning lamp

    Blind Spot Detection Indicator Components and Components Location
    Components ...

    Troubleshooting
    Troubleshooting Examples of False-Alarm Occurrence from system characteristics (It’s not a problem) - Characteristics of EM Wave : EM Waves are reflected against all material and especially me ...

    See also:

    3. Exhaust emission control system
    The Exhaust Emission Control System is a highly effective system which controls exhaust emissions while maintaining good vehicle performance. Vehicle modifications This vehicle should not be mo ...

    Lower Arm Repair procedures
    Removal [Front Lower Arm] Replacement the lateral arm 1. Removal the front wheel & tire. Tightening torque : 90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft) 2. Disconnect ...

    This device complies with Part 15 of the FCC Rules.
    Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may c ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com