Because of the design layout, the air spring and the shock
absorber (damper) is separated. The average (target) pressure of rear
air spring for normal operation is around 8.5 bar.
When the rear air spring is delivered as service spare part,
no air is filled so that the intensive care is required to handle. It
will be explained more detail in the section of ‘Caution of
handling’.
Due to the stopper inside of spring, the upper end and lower
end do not contact (gap exists around 10mm) each other even if the air
is totally discharged.
Take care to handle the rear air spring. Don’t pull the air
spring intentionally, it may very difficult to restore to the original
shape. If it was extended untended, a small amount of air pressure
inside spring will help you pushing the spring to the original position.
Components
1. Urethane pad2. Connected to air tube3. Protector4. Air spring
...
Removal
•
Before replacing the relevant parts, use GDS equipment to fully discharge the air from the relevant parts.
(Refer to Air Suspension System - "Repair procedures ( ...
See also:
Parking assist system
The parking assist system assists the driver during movement of the vehicle by
chiming if any object is sensed within the distance of 39 in (100 cm) in front or
47 in (120 cm) behind the vehicle ...
Repair procedures
Inspection
Relex Power Seat Module (RPSM) For Passenger & Rear
Glossary
-
RPSM : Relax Power Seat Module
-
Combined RELAX SW : Combined RELAX SWITCH
-
Combined WALK IN SW : Combin ...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it with the lever
in the OFF position. The wipers will operate conti ...