>
Inspection |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover") |
3. |
Disconnect the power seat air lumber support switch connector (A). |
4. |
With the power seat air lumber support switch in each position, make sure that continuity exists between the terminal below.
If continuity is not as specified, replace the switch.
|
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the seat back cover.
(Refer to Body - "Front Seat Back Cover") |
3. |
Disconnect the air lumber tripple valve unit connector.
|
4. |
With supplying the voltage to the air pump in each position, check that the air lumber support is operated properly.
|
Pantoscopic Camera Components and Components Location
Components
...
Schematic Diagrams
Circuit Diagram
...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...