Accelerator Position Sensor (APS) is installed on the
accelerator pedal module and detects the rotation angle of the
accelerator pedal. The APS is one of the most important sensors in
engine control system, so it consists of the two sensors which adapt
individual sensor power and ground line. The second sensor monitors the
first sensor and its output voltage is half of the first one. If the
ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the
diagnostic system judges that a malfunction has occurred.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Specification
AcceleratorPositionOutput Voltage (V)APS1APS2C.T0.7 ~ 0.80.33 ~ 0.43W.O.T3.85 ~ 4.351.93 ~ 2.18
...
See also:
Rear Hub - Carrier Components and Components Location
Component
1. Rear hub assembly2. Dust cover3. Rear knuckle4. Rear brake disc
...
Seat Belt Pretensioner (BPT) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the safety belt (A) by turning it in the direction of arrow using a flat ...
Repair procedures
EOL Input
Description
When shift shock is occurred or parts related with the transmission are replaced, EOL should be performed.
In the following case, EOL is required.
•
Transmission assem ...