Hyundai Equus: Accelerator Pedal Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Disconnect the accelerator position sensor connector (A). |
| 3. |
Disconnect the accelerator control connector (B). |
| 4. |
Remove the accelerator pedal in the direction of "Removal direction" in the figure after removing the installation bolt (B).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Accelerator Pedal Description and Operation
Accelerator Pedal
Intelligent Accelerator Pedal (IAP) communicates with various modules by CAN communication.
IAP alarm the driver with foot power control and the vibration.Operation
...
Delivery Pipe Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...
See also:
Trunk Lid Trim Components and Components Location
Component Location
1. Trunk lid trim
...
Knee Airbag (KAB) Module Description and Operation
Description
The Knee Airbag (KAB) is installed inside the crash pad lower
panel and protects the driver in the event of a frontal crash. The
SRSCM determines if and when to deploy the KAB.
...
Components and Components Location
Components
1. Backing plate2. Operating lever3. Upper spring4. Lower spring5. Adjuster6. Shoe hold down spring7. Shoe hold down pin8. Parking brake shoe9. Cup washer
...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com