>
Hyundai Equus Manuals

Hyundai Equus: A/C Pressure Transducer Repair procedures - Air Conditioning System - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: A/C Pressure Transducer Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / A/C Pressure Transducer Repair procedures

Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”.

2.
Inspect the voltage value whether it is sufficient to be regular value or not.

Voltage = 0.00878835 * Pressure + 0.37081095
3.
If the measured voltage value is not wihtin specification, replace the A/C pressure transducer.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).
Tightening torque :
10 ~ 12 N.m (1.02 ~ 1.22 kgf.m, 7.4 ~ 8.8 lb-ft)

   
Be careful not to bend the liquid & suction pipe.
Support the hex portion of the pipe with a wrench while removing or installing the A/C pressure transducer.
5.
Install in the reverse order of removal.
   
When installing, replace it with a new O-ring (A).

    A/C Pressure Transducer Description and Operation
    Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the coolin ...

    Evaporator Temperature Sensor Description and Operation
    Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. ...

    See also:

    4&OD Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Fuel Pump Control Module (FPCM) Specifications
    Specification ltemSpecificationSupply Voltage (V)8~18Supply Current (A)Max. 10Fuel Pressure (kpa)Starting600Drive350 ~ 500Stop20  Under ...

    Schematic Diagrams
    Trouble Symptom Charts Component Parts And Function Outline Component partFunctionCruise Control SwitchInput the set speed and distance to the SCC ECU.Instrument ClusterDisplay various information ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com