>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams
Circuit Diagram
...
Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition swit ...
Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...